End Of Programme; Energy Management - Miele PFD 101 Operating Instructions Manual

End of programme

The buzzers might sound at the end of
the programme.
The programme has ended when the
display shows the message 
In some programmes, if the "AutoOpen"
function is activated, the door will
automatically open slightly (see the
"AutoOpen" section in the "Settings"
chapter). This improves the drying
process.
If the
Consumption
function is switched on, you can now
call up the actual water consumption of
the programme that has just finished
(see the "EcoFeedback consumption
indicator" section in the "Caring for the
environment" chapter).
The drying fan may continue to run for
a few minutes at the end of the
programme.

Risk of damage due to steam.
Steam from the dishwasher could
damage the edges of worktops when
you open the door at the end of the
programme if the fan is no longer
running.
If you have deactivated the
automatic door opening function (see
the "AutoOpen" section in the
"Settings" chapter), but would still
like to open the door at the end of
the programme, then make sure that
you open the door fully.
Finished
programmable

Energy management

To save energy the dishwasher will
switch off automatically 10 minutes
after the last time a sensor control is
pressed or after the end of a
.
programme.
You can switch the dishwasher back on
again with the  sensor control.
If the dishwasher has been switched off
for longer than 1 minute, you will need
to hold the  sensor control for a bit
longer (wipe protection).
The dishwasher will not switch itself
off whilst a programme is running or if
there is a fault.
Operation
51