Advertisement
Quick Links
Advertisement
Related Manuals for Ballard Designs Tuscan Center Bookcase with Cabinet MV397
Summary of Contents for Ballard Designs Tuscan Center Bookcase with Cabinet MV397
- Page 1 Customer Service: 800-367-2810 Online: www.ballarddesigns.com PRODUCT NAME: Tuscan Center Bookcase with Cabinet ITEM NUMBER: MV397 ASSEMBLED DIMENSIONS: 85 3/4”H x 37”W x 18 3/4”D PRODUCTS ARE NOT INTENDED IMPORTED FOR COMMERCIAL USE. UPDATED: 4-27-2021 Page 1 of 7...
-
Page 2: Required Tools
NOTE: Assemble in intended area for use. Shelves (E,F) Hardware Located Here (A-E) Remove all parts, hardware and protective packaging from carton and carefully arrange on a clean, level, padded surface. NOTE: To avoid accidentally REQUIRED TOOLS: discarding small parts or hardware, -Phillips &... -
Page 3: Step 1: Install Shelves
NOTE: Assemble in intended area for use. STEP 1: INSTALL SHELVES Determine shelf height, then insert Shelf Supports (B) into pre-drilled holes. Gently lay in Wood Shelf (E) then Glass Shelves (F). All should rest level upon each Shelf Support. STEP 2: LEVELERS If necessary, the Bookcase may be leveled by adjusting LEVELERS located on the bottom of each corner which are accessible INSIDE the Cabinet. - Page 4 STEP 3: LOCATE AND MARK WALL STUDS FOR ANTI-TIP HARDWARE Bookcase includes two L-Brackets (C), at least one of which MUST BE SECURED TO A WALL STUD. First, push Bookcase against wall and position over wall stud(s). Use a pencil to mark stud locations. Wall Studs WARNING Tip-Over Hazard...
- Page 5 STEP 5: ATTACH BRACKETS TO WALL Carefully pull Bookcase away from wall and attach Wall Brackets (C) at marked locations. Use Screws (A) for anchoring and securing Bracket to a Wall Stud. Wall Stud Wall Stud STEP 6: ATTACH BRACKETS TO TOP OF BOOKCASE Carefully slide Bookcase under each of the previously installed L-Brackets (C) and use two or more Screws (A) to attach L-Brackets to top of Bookcase.
-
Page 6: Cleaning And Care
STEP 7: BOOKCASE LIGHTING Plug electrical cord into an outlet. Cabinet is equipped with an “Easy Touch” dimmer control which allows for three levels of brightness. To operate, touch upper right steel plate. Easy Touch Touch steel plate for 3-level light control Cleaning &... - Page 7 NOTE: Save this page for future bulb replacement. HALOGEN BULB REPLACEMENT: Qty. Item needed Halogen JCD G8 120V 25W Replacement Bulb (A) NOT INCLUDED Unplug the unit from the wall. Remove the Lens Cover (B) from the Fixture Body (C) by turning it counter clockwise and pulling it away from the unit.