Operation - Graco IM5 Instructions And Parts List

Operation

Operation
Sleep Mode
The meter automatically shuts down the display after
one minute of non-use.
Activation Mode
There are two ways to activate the display:
• Press any button on the keypad to wake up the dig-
ital display. The amount displayed is the value
stored when the meter went into sleep mode.
• Dispense fluid through the meter to wake up the
digital display. Dispensing fluid through the meter
causes the meter to count up from the last dis-
played value. See Fig. 2.
Function of TOTAL
Press and hold the TOTAL key to see the accumulated
total of fluid dispensed through the meter.
The accumulated total is shown in gallons when the unit
of measurement is set in gallons, quarts, or pints. The
accumulated total is shown in liters when the measure-
ment is set in liters. The meter accumulates a running
total of up to 99,999 gallons (or liters) dispensed before
returning to zero. See Fig. 3.
Function of RESET
Press and hold the RESET key to clear the digital dis-
play after each dispense cycle.
NOTE: Always press the RESET key to clear the digital
display before each new dispense cycle.
For Maximum Dispensing Accuracy
Set the meter to dispense in pints or quarts when dis-
pensing 1 gallon (3.8 liters) or less.
Measurement Units
Fig. 4 shows the various measurement units as they
appear on the display.
6
F . 2: Example of Total for Last Dispense Cycle
IG
F . 3: Example of Accumulated Total
IG
F . 4: Example of Measurement Units
IG
308687L