Renault LAGUNA 2000 Manual page 53

F4P engine
Procedure for tensioning the timing belt
The tension wheel rollers and timing pulley must
be replaced when the timing belt is replaced.
Ensure that the lug (1) of the tension wheel is
correctly positioned in the groove (2).
Refit:
– the timing belt,
– the pulley (3) tightening the bolt to a torque of 4.5 daNm,
– the crankshaft accessories pulley, pre-tightening the bolt (without
locking the bolt, clearance of 2 mm to 3 mm between the bolt and
the pulley).
NOTE:
– the crankshaft accessories pulley bolt can be reused if the length under
its head does not exceed 49.1 mm (otherwise replace it),
– do not oil the new bolt. However, the bolt must be oiled on the threads
and under the head if it is being reused.
VALUES AND SETTINGS
07-36
07