Renault LAGUNA 2000 Manual page 50

VALUES AND SETTINGS
07
F4P engine
Procedure for tensioning the timing belt
nd
2 PROCEDURE
The second procedure is used for
replacing all components located
on the front of the timing which do
not require the exhaust camshaft
pulley and the inlet camshaft
dephaser to be undone.
Adjusting the timing
WARNING: it is essential to
degrease the end of the
crankshaft, the bore of the
crankshaft pinion and the bearing
faces of the crankshaft pulley to
prevent any slip between the
timing and the crankshaft which
would risk destroying the engine.
Position the grooves of the camshafts
using tool Mot. 799-01 as shown in
the diagram opposite.
Fit tool Mot. 1496, on the ends of the camshafts.
07-33