Lift Adjustment; Preparation Before The Adjustment; Adjustment Procedure - Launch TLT235SBA User Manual

LAUNCH

11. Lift Adjustment

11.1 Preparation before the adjustment

Lubricate contact surface of the carriage and corners

11.2 Adjustment procedure

1. DOWN button
5. Buzzer 6.Maintenance alarm 7
Note ： ： ： ： This equipment needs NFB (non-fuse
breaker) upon installation. This equipment does
not include it. It should be bought and installed by
users. 16A NFB is suggested.
Check if the motor power is installed correctly.
Check if all connecting Bolt s are fastened.
Operation procedures as follow:
1.Automatic/Manual
switch is in automatic position , the operation is as
below:
UP button ： P ress UP button to rise, release button to
stop rising. The maximum lifting height can reach
to the upper limit switch position.
Safety lock button
fall on the safety lock .This button is merely a
lowering button.
Down button K eep pressing DOWN button, first it
：
rises about 2 seconds and disengage the safety lock
simultaneously. Then it lowers ,until to the lower limit
switch C E-STOP
（
the DOWN button to let it fall down the bottom
gradually.
Buzzer alarm When lowering to the lower limit switch
：
(C) Diagtools; www.diagtools.eu; diagtools@diagtools.lv; Pernavas 43A, Riga, Latvia, LV-1009; +37129416069
2. Safety lock button 3. UP button 4.
2 20V waterproof socket
、
A C/MC w hen change-over
（ ）
P ress this button to let carriage
：
. Then restart to keep pressing
）
Electronic
of column with general-purpose lithium grease. All
sliding surface should be coated evenly from top to
bottom.
Fill hydraulic oil N32 or N46 to the oil reservoir of the
power unit.
Automatic/Manual switch button
8. Power switch
position （ C E-STOP ） , the lowering motion would
be stopped. Repress the DOWN button, it begins to
lower again with alarm buzzer, release the DOWN
button, the alarm buzzer would stop.
2. Automatic/Manual
（
switch is in manual position , the operation is as
below:
UP button U P P ress UP button to rise, release
（ ） ：
button to stop rising. When it reaches to the limit
switch position, the rise would stop even the button is
being pressed.
Down button P ress this button to lower, release this
：
button to stop lowering
Safety lock button P ress this button to lock, release
：
this button to release the lock
When the number of lifting times is reaching 3000,
there will be acoustic and optical alarm warning, to
suggest that the lift should be taken maintenance.
Bleeding is required for newly installed hydraulic
system .When connection pipes ,the hydraulic
cylinder should be at its lowest position for minimum
air cavity ,then raise and lower for several times .
The adjustment is finished.
31
Two-post User's Manual
A C/MC w hen change-over
）