Table of Contents
Advertisement
L a u n c h
10.2.11 Install the swing arm
Install the swing arm as Fig.17
Check if the positioning gear mechanism at the end of arm
fits, adjust the Screw s of fixed semi-gear for its fitness.
Note: ：
During the installation, lubricate the moving parts of
swing arm and carriage ,so that the swing arm can move
freely.
Make sure the arm positioning gear is engaged!
11. Lift Adjustment
11.1 Preparation before the adjustment
Lubricate contact surface of the carriage and corners of column with general-purpose lithium grease. All sliding surface
should be coated evenly from top to bottom.
Fill hydraulic oil N32 or N46 to the oil reservoir of the power unit.
11.2 Adjustment procedure
Check to see if the power supply is installed properly
Check for the tightness of all the connecting bolts.
Press the start button on the motor, and the carriage rises; stop pressing the button, then the carriage will stop.
In order to lower down the carriage, first pull the safety lock handle on the column If it can't be pulled, raise a
little and pull again .At the same time press the lowering handle on the power unit and the carriage will be
lowered; stop pressing the handle, then the carriage will stop. When repairing, after the vehicle is lifted up to the
required height, first press the lowering handle to actuate the mechanical safety lock in order to ensure the
safety operation.
The hydraulic system may contain air due to new installation, to bleed the air, repeat the lifting and lowering for
several time
The adjustment is completed
T L T 2 6 0 A T T w o - p o s t l i f t u s e r ' s m a n u a l
14
Fig. 17
Advertisement
Table of Contents
