Operation - Silvercrest SHT 2000 A1 Operating Instructions Manual

RP75978 Heiztower LB1 Seite 60 Mittwoch, 29. August 2012 3:44 15
that the maximum load for the installed
fuse is not exceeded, as otherwise the
fuse will trip.
5.2 Insert batteries
If the appliance is new or the batteries in the
remote control are flat, new type AAA
batteries must be inserted.
1. Open the battery compartment of the
remote control by sliding the battery
compartment lid down.
6.1 Displays
The selected function is shown in the
display 10.
A B C
G
F
A Fan running
B High heat. The appliance operates at
2,000 watts
C Low heat. The appliance operates at
1,000 watts
D Timer operating time
E Display of room temperature
F Display of set required temperature
G Frost protection is activated
60
2. Remove the old batteries if present.
Note: Please observe the instructions
for disposal (see "9.2 Disposable/
rechargeable batteries" on page 64).
3. Insert new batteries.
Note: Ensure the correct polarity (+/–)
when inserting the batteries. The correct
polarity is marked on the battery
compartment.
4. Slide the lid back onto the battery
compartment.

6. Operation

6.2 Remote control
The appliance can be operated using the
control panel 2 or the remote control 23.
The numbers in the text below refer to the
control panel 2 and/or the remote
control 23.
6.3 Switching the appliance on and off
D
1. Insert the mains plug into a wall socket
that complies with the technical data
E
(see "3. Technical data" on page 56).
2. Switch the mains switch 5 to "ON" to
switch on the power supply.
The mains switch 5 lights up.
3. To switch the appliance on, press the
On/Off button 16 or 22.
The display 10 shows the current room
temperature.