Operation - Silvercrest SKT 2000 B1 Operating Instructions Manual

RP100157 Konvektor Timer LB1 Seite 45 Mittwoch, 11. Juni 2014 12:30 12
Notes:
• As the appliance and heating coils are
supplied with a thin film of grease, there
might be a small amount of smoke and
odour the first time the appliance is
used. This is not harmful and will stop
after a short time. Ensure adequate
ventilation during this process.
• If you have plugged other power
consumers into the same circuit, check
that the maximum load for the installed
fuse is not exceeded, as otherwise the
fuse will trip.
6.1 Using the appliance for the first time
and switching off
1. Insert the mains plug into a mains socket
that complies with the technical data
(see "3. Technical data" on page 40).
2. Set the main switch 14 to "I" to switch
on the power supply.
The appliance is now ready to use.
3. Set the main switch 14 to "0" to switch
off the power supply.
SKT 2000 B1

6. Operation

6.2 Setting the heating setting
The heating settings are used to select how
quickly the appliance heats up.
The appliance has three heating settings:
– Level 1: 750 watts: Press switch 6;
– Level 2: 1250 watts: Press switch 5;
– Level 3: 2000 watts: Press switches 5
and 6.
If you want the appliance to heat up
particularly quickly, select level 3. If you only
want it to heat up slowly, select level 1.
A red indicator lights up in the activated
switches as soon as the appliance starts to
heat up.
If no switch is pressed, the appliance will not
produce any heat.
6.3 Selecting the temperature
Set the required temperature with the
temperature selector 8.
• When the required room temperature is
reached,
temperature selector 8 until you hear a
quiet "click".
The red indicators in the switches 5
and 6 will be extinguished.
The current room temperature will be
maintained.
As soon as the appliance needs to heat
up again to maintain the temperature,
the red indicators in the switches 5
and 6 will light up once again in the
meantime.
slowly turn down
45
the