Assembly; Initial Operation - Silvercrest SOR 2600 B1 Operating Instructions Manual

Assembly

GB
Use the fold-out page of these instructions to assist
you with assembly.
1) Remove the oil radiator and all components from
the box and remove all packaging materials.
2) Place the oil radiator, with the base uppermost,
on a soft surface, for example a carpet.
3) Place a mounting bracket 8 under the heater
element so that the threaded parts project
upwards.
4) Lay a roller rail 9 over it, such that the screw
threads protrude through the holes. Check to
ensure that the recesses on the roller rails 9
are facing outwards. The screw ends project-
ing from the appliance must reach into the
recesses.
5) Screw one wing nut 0 hand tight onto each of
the threaded ends of the mounting bracket 8.
6) Proceed in the same manner with the other side.
7) Turn the appliance over and place it on the rollers.

Initial operation

1) Unwind all of the power cable from the power
cable retainer 7.
NOTE
Ensure that the thermostat 3 and the heat
►
level switch 2 are standing at MIN resp. 0.
2) Insert the plug into a mains power socket.
3) Set the heat level switch 2 to "III" and the
thermostat 3 to MAX. The "Power" control
lamp 1 illuminates.
6
NOTE
You can use the heat level switch 2 to regu-
►
late how quickly the appliance warms up.
If you wish to heat it up particularly quickly,
select heat level "III", if a slow warming up is
preferred, select heat level "I".
Using the thermostat 3 you can set it to the
desired temperature.
4) When the desired room temperature has been
reached, slowly turn the thermostat 3 back
down until a quiet "click" is heard and the
"Power" control lamp 1 goes out. The current
room temperature will now be retained. The
"Power" control lamp 1 will light up occasion-
ally then switch back off after a short while.
This merely means that the programmed room
temperature has fallen below this level for a
short period and the appliance has warmed
itself back up.
NOTE
► If you want to heat a room up particularly
quickly, you can also activate the heating fan
switch 4. When the fan heater is switched
ON, the heating fan control lamp 4 illumi-
nates and hot air is blown through the hot air
outlet 5 into the room.
5) If you wish to switch the appliance off , fi rst set the
heating fan switch 4 to OFF so that the heating
fan control lamp 4 goes out. Next, turn the
heat level switch to 2 to "0" and then the
thermostat 3 to MIN.
6) Remove the plug from the mains power socket.
SOR 2600 B1