NOMA Quatra 052-9329-2 Instruction Manual page 6

6
Toll Free: 1-866-827-4985 model no. 052-9329-2
ASSEMBLY
Installation:
The installation is to be in accordance with the National Electrical Code, ANSI/NFPA 70 and local codes.
1. Mounting bracket
.
Remove the canopy from the mounting bracket by removing
the two mounting bracket screws and star washers from the
round holes in the canopy. Then loosen the other two mounting
bracket screws from the L-shaped slots. Retain the mounting
bracket screws and star washers for later. (Figure 1)
.
With wiring extending out of downrod, cut the excess wire
with wire cutter (not included). Then strip
mounting bracket. Rotate the downrod until the tab in the
mounting bracket is seated in the slot in the downrod ball.
(Figure 2)
.
For best fan performance and safety, make sure the mounting
plate is fitted to a level ceiling joist or ceiling support. If the
mounting position is not level, hard packing material should be
used to make the plate level.
2. Drop-mount
. Slide downrod through canopy and flange cover.
. Thread electrical wires through downrod and pull extra wire
slack from the upper end of the downrod.
. Loosen yoke set screw and nut and remove pin if preinstalled.
Place downrod into the motor housing and insert pin.
Tighten yoke set screw and nut securely. (Figure 3)
3. Attach blade to motor
. Locate 12 blade attachment screws in hardware pack. Slide
blade through motor and align holes. Insert 3 blade attachment
screws with finger. Tighten securely with a screwdriver
(not supplied). Repeat for the remaining blades. (Figure 4-1)
. Install the light kit up to the motor housing and turn clockwise
until tight (Figure 4-2)
downrod into the
Figure 1
Mounting
bracket screw
Figure 2
Mounting
Tab
bracket
Figure 3
Downrod
Flange
Yoke set
screws
Figure 4-1
Figure 4-2
Slot
Downrod
Canopy
Pin
Blade
Blade