Parameters List - Siemens S120 PM240-2 Manual

At this point the system is ready to be used and configured.
Any additional tune-up can be done by acting directly on the values of the parameters of the Drive available
in the list "User" or BOP , as explained in detail in paragraph 11.4 .
ATTENTION: Only in case of change of the inverter or of the electric motor, you must do motor
recognition by P1910, before performing any calibration. Please contact OMARLIFT Service, for the
procedure.
11.3

PARAMETERS LIST

Below are listed the parameters of the list "User " and their default values:
After the modify of the parameters of interest, it is always necessary to save the new values on
the hard memory of the Control Unit (with button RAM to ROM), in order to prevent a loss of data at the
first shut down (voluntary or accidental). Using WEBSERVER software, you have to switch ONLINE, then
press the push button RAM to ROM . Alternatively, see the procedure described to the chapter 10 for the
setup by BOP.
Table 16 List of parameters
ID Description
SETTING UPWARDS DIRECTION - CONFIGURAZIONE SALITA
p21502 Pre-Start Speed (2.2.2)
p21503 Pre-Start Time (2.2.3)
p21507 High Speed (2.2.6)
p21512 Low Speed (2.2.7)
p21513 Final Dec Time (2.2.14)
p21514 Inspection Speed UP (2.2.9)
p21515 Releveling speed UP (2.2.8)
SETTING DOWNWARDS DIRECTION - CONFIGURAZIONE DISCESA
p22011 Pre-Start Speed value 2 (2.3.2.2)
p22017 Pre-Start Time value 2 (2.3.3.2)
p22023 Pre-Start Delay Additional value 2 (2.3.3D.2)
p21537 High Speed (2.3.6)
p21542 Low Speed (2.3.7)
p22081 Final Dec Time value 2 (2.3.14.2)
p21544 Inspection Speed DOWN (2.3.9)
p21545 Releveling speed DOWN (2.3.8)
p21630 Plus Speed while EDV closing
RUPTURE VALVE TEST- TEST VALVOLA PARACADUTE
p21523 Parachute function (2.13.1)
p21524 Overspeed Factor
p21525 Ramp-up time (ms) (2.13.3)
p21526 Ramp-down time (ms) (2.13.5)
p21527 Max. Time Parachute (ms)
p21529 Parachute Max.Speed TimeOut (2.13.4)
EMERGENCY MODE - MODALITÀ EMERGENZA
p21546 Emergency Speed Up (2.6.1)
p21547 Emergency Speed Down (2.6.2)
p21650 Emergency Ramp Adaption
SHORT FLOOR - PIANO CORTO
11-2
Valore Unità
Value Unit
0.040 %
800.000 ms
0.750 %
0.095 %
4.500.000 ms
0.300 %
0.120 %
-0.002 %
100.000 ms
500.000 ms
-0.750 %
-0.090 %
800.000 ms
-0.300 %
-0.020 %
0.080 %
0
1.500
2.000.000 ms
1.500.000 ms
15.000.000 ms
4.000.000 ms
0.200 %
-0.150 %
1.000
Siemens PM240-2_EN_rev00-30082019.docx
MAX min
0.060 0.020
1000 500
1.000 0.600
0.12 0.060
6000 3000
0.400 0.100
0.150 0.080
0.020 - 0.020
300 100
1000 100
-1.000 -0.600.
-0.120 -0.060
1000 500
-0.400 -0.100
-0.150 -0.080
0.120 0.060
NA NA
NA NA
NA NA
NA NA
NA NA
NA NA
1.000 0.100
-1.000 -0.100
NA NA