Mounting
The diagrams show how to mount the Basic Operator Panel BOP20 on a CU310-2
1. Remove the blind cover by
pressing on the tabs to snap and
pull the front.
NOTE:
The BOP20 may be inserted or withdrawn while the Control Unit is operational.
Removal
1- Simultaneously press the latching cams on the BOP20.
2- Keep the latching cams pressed together and pull the BOP20 straight out.
3- Insert the blanking cover.
Display and operator controls of the BOP20
For information about display and operator controls of the BOP20, refer the SINAMICS S120 Commissioning
Manual (IH1).
10-6
2. Squeeze the tabs on the joint
BOP20 and insert it directly into
the housing of the CU310-2 until it
clicks into place.
CU310-2 with BOP installed.
Siemens PM240-2_EN_rev00-30082019.docx