Disposal - oventrop X-25 Operating Instructions Manual

Disposal

10. Loosen all electrical supply lines at your
new controller and put the sensors and
supply lines to one side.
The components no longer required
can be used as spare part in case of
a sensor malfunction.
11. Place the new controller in the installation
position.
12. Connect the electrical connections ac-
cording to the terminal assignment (see
operating instructions of your fresh water
station).
13. Secure the lines in place with suitable cable
ties to relieve tension.
14. Close the supply line cover and the con-
nection panel cover.
15. Tighten the screw.
16. Put the controller back from the installation
position to the operation position (see Illust.
2 on page 16).
17. Make sure that the electrical lines are laid in
the designated channels in the lower shell.
NOTICE
Sensor malfunctions due to elec-
tromagnetic signal coupling
When laying alive cables and sensor
cables in one channel, the sensor signal
can be interfered by couplings.
f Lay the sensor cables and alive
cables in separate channels.
18. Fit the upper shell.
19. Connect the station to the power supply.
Z If different software versions are installed
on the touch operating element and the
controller, the versions are adjusted. This
happens automatically and is displayed
by running dots in the touch operating
element. The software adjustment can
take up to 2 minutes.
18
Controller X-25/X-45
NOTICE
Malfunctions due to voltage
interruption
If you interrupt the power supply of the
touch operating element while the soft-
ware versions of the controller and the
touch operating element are adjusted,
this may lead to malfunctions and even
a breakdown of the touch operating
element.
f Do not interrupt the power supply of
the station and do not remove the
upper shell if a software adjustment
is displayed by running dots in the
touch operating element.
Z The fresh water station is ready for
operation.
6. Disposal
Directive 2012/19/UE WEEE:
Waste electrical and electronic
components (WEEE) must not
be disposed of with domestic
waste, but must be dropped off
at a collection point of the recy-
cling of electrical and electronic
appliances.
NOTICE
Risk of environmental pollution
Incorrect disposal (for instance with
domestic waste) may lead to environ-
mental damage.
f Dispose of packaging material
in an environmentally friendly
manner.
f Dispose of the components appro-
priately.
138116080-V01.04.2020