Troubleshooting - Zanussi ZOB35301XK User Manual

Step 8 Clean the glass panels with water and
soap. Dry the glass panels carefully. Do
not clean the glass panels in the dish-
washer.
Step 9 After cleaning, install the glass panel
and the oven door.
The screen-printing zone must face the inner
side of the door. Make sure that after the instal-
lation the surface of the glass panel frame on
the screen-printing zones is not rough when
you touch it.
When installed correctly the door trim clicks.
Make sure that you install the internal glass
panel in the seats correctly.
HOW TO REPLACE: LAMP
WARNING! Risk of electric shock.
The lamp can be hot.
Step 1
Turn off the oven. Wait until the
oven is cold.
Back lamp
Step 1 Turn the glass cover to remove it.
Step 2 Clean the glass cover.
Step 3 Replace the lamp with a suitable 300 °C heat-resistant lamp.
Step 4 Install the glass cover.

TROUBLESHOOTING

WARNING! Refer to Safety chapters.
WHAT TO DO IF...
In any cases not included in this table please
contact with an Authorised Service Centre.
22
Always hold the halogen lamp with a cloth to
prevent grease residue from burning on the lamp.
Before you replace the lamp:
Step 2
Disconnect the oven from the
mains.
Put a cloth on the bottom of
Problem
The oven does not
heat up.
A
Step 3
the cavity.
Check if...
The fuse is blown.