6.
7.
QS10005_V1.0_EN
Select the connection method "Ethernet connection via a hub" and enter the default IP
address 192.168.250.001 for the host controller.
Make sure your PC uses an IP address in the same subnet, e.g. 192.168.250.50.
To check the communication, select "Ethernet Communication Test". If "Test OK" is
displayed, the communication is active.
Select "OK" to save your settings.
Select the yellow triangle in the tool bar to go online.
When the host controller is in RUN mode, the new status is displayed on the lower
right.
4 Create a project in Sysmac Studio
15