Table of Contents
Advertisement
AquaPrep 055
2. Using a pointed object, remove the fuse block and cover assembly from the power
connector on the rear panel of the AquaPrep.
3. Pull the voltage selector card straight out of the power connector housing.
4. Orient the voltage selector card so that the desired voltage is indicated at the bottom.
Orient the indicator pin so that it points upward as shown in the following illustration.
Indicator Pin
Voltage
5. Insert the voltage selector card into the power connector housing with the edge containing
the desired voltage first and with the printed side facing the power ON/OFF switch.
Oct 09
Installing the AquaPrep
2-3
Advertisement
Table of Contents
Need help?
Do you have a question about the AquaPrep 055 and is the answer not in the manual?
Questions and answers