Upacking Components; Figure 2-2 Unpacking Components - Raisecom ISCOM6820-GP Installation Manual

Hide thumbs Also See for ISCOM6820-GP:

Table of Contents

Raisecom

ISCOM6820-GP (A) Installation Guide

2.3.3 Upacking components



Pay attention to the following items in the process of unpacking components:



Unpack components according to the following steps:

Step 1 Check each packing box of the components to see whether there is obvious damage.

Step 2 Wear an ESD wrist strap and make it grounded properly.

Step 3 Unpack each box and take components out, as shown in Figure 2-2.

Step 4 Check whether the components are damaged and choose the corresponding processing

method. Execute step 5 if the components need to be installed immediately; if not, execute

step 6.

Step 5 Put card on the surface of antistatic materials for electro discharge treatment, and then install

them.

Step 6 Pack the components again with original packing materials, and store them in a dry and cool

environment to avoid sunlight and interference from strong electromagnetic radiation source.

Electronic components are vulnerable to Electro Static Discharge (ESD) damage.

When unpacking components, you need to wear a properly grounded ESD wrist

strap and contact the edge of components only.

Stop unpacking the box immediately if the components are found rusted or

dampened during the unpacking process. Give feedback to the local Raisecom

office after finding out reasons together with Raisecom engineers.

Take anti-static protection measures to avoid components damage.

Pay attention to the impact of environmental temperature and humidity.

Take the edge of the circuit board to avoid touching the PCB components and printed

circuits with hands.

Raisecom Proprietary and Confidential

2 Preparing for installation

Table of Contents