Led Behavior - CalAmp LMU-5541 Hardware Installation Manual

Default gateway = 192.168.1.55
Select OK to apply changes.
6.2 Connect to the router
LMU-5541 Hardware & Installation Guide
30/49
Use a web browser to log into the LuCI interface. Type 192.168.1.55 into the browser:
6.3 LuCI
Login screen:
Enter Username: root
Enter Password: wireless3g
Once you log in you will see the Overview screen:
LMU-5541 Hardware & Installation Guide
31/49
6.4 How to turn on WIFI
To start the WIFI interface you can simply run the following PEG command:
Note: By default the WIFI interface is configured in Access Point mode with no security.
It is disabled after programming the image.
To start the WIFI interface you can simply run the following PEG command:
LMU-5541 Hardware & Installation Guide
32/49
>>at$app peg action 190 1
To shut down WIFI run the following PEG command:
>>at$app peg action 190 0
To see WIFI status:
>>atiw
From Linux console you can also turn WIFI on/off using the following commands:
To turn on WIFI:
>> uci set wireless.radio0.disabled=0
>> uci commit wireless
>> /etc/init.d/network reload
To turn off WIFI:
>> uci set wireless.radio0.disabled=1
>> uci commit wireless
>> /etc/init.d/network reload
You can also turn WIFI on/off using the LuCI:
From the Overview page, click the Network tab and then the WIFI sub-tab.
6.5 How to test WIFI connectivity
As we mentioned, WIFI on the LMU5530 default is in access point mode so all clients can join it and get an IP address.
If you run WIFI on the LMU5530 from your Windows or Linux machine with WIFI enabled, you should see a new WIFI device with "calamp"
as the SSID.
Try to join this network. It has no security and it should join "calamp" with no problem.
33/49
After joining you should check your WIFI interface
LMU-5541 Hardware & Installation Guide in client
side to see if it got a new IP address.
On Windows machines, go to console by running "cmd" and from there type
>>ipconfig
You should see new IP address with 192.168.100.xx subnet is assigned to wireless interface.
You can try to ping the LMU from the client side:
>>ping 192.168.100.55
Ping should work.

6.6 LED Behavior

Mode Connected? Client Connected? LED State
OFF NO OFF
Client NO Green Flash (Slow)
Client Authenticating Green Flash (Fast)
Client YES Green Solid
AP NO Red Solid
AP YES Red Solid
6.7 Toggle between Access Point and Client Mode
You can switch between Access Point and Client Mode by changing Parameter 3901 (WIFI_MODE) and restarting the Wi-Fi interface.
Putting unit into Access Mode:
>>at$app param 3901,0,"ap"
>>at$app peg action 190 1
Putting unit into Client Mode:
>>at$app param 3901,0,"sta"
>>at$app peg action 190 1
6.8 Supported and Tested Wi-Fi Related Parameters
WIFI_AUTH = 3900 //16-char - AUTh mode