Using The Dc 2300; Working Mode; Recording Mode - BenQ DC 2300 User Manual

BenQ DC 2300 User's Manual
3. U
SING THE
The functions of DC 2300 are mainly composed of four modes: Recording mode, Playback
mode, Video Mode, and Setup Mode. In this chapter, we will introduce the functions of DC
2300 according to these four modes.

3.1. Working Mode

3.1.1. Recording Mode

Please set the Mode Dial at Recording Mode (
the below functions.
I. Set Up Focus Range
Before you take pictures, please make sure you set the Focus
Switch at the correct focus range or the image may not be clear.
a. Macro (
b. Portrait (
c. Normal(
If the Focus Switch is set at (
Monitor to remind you that the focus is not set at Normal focus range.
II. Turn On or Turn Off the LCD Display (Preset at On status)
The TFT LCD Monitor is automatically turned on when the camera is switched
on. To turn off the TFT LCD Monitor please press LCD Button. To turn on the
TFT LCD Monitor please press LCD Button again.
III. Set Up Flash Mode (Preset at Auto Flash mode)
There are five flash modes as below:
a. Auto flash(
environment is too dark the flash will fire automatically.
b. Auto flash with red-eye reduction(
using the flash and reduce the chance of red-eye reduction.
c. Slow sync (
light to make good images in low light circumstances. Under this mode, it is
suggested to use a tripod to make sure the camera is held still while taking the
picture.
d. Fill-in-flash(
e. Flash off (
DC 2300
): 18~25cm.
): 80cm~1.3m.
): 1.3m~infinity.
): The camera will judge the necessity of using the flash. If the
): The shutter speed will become slow in order to catch more
): The flash will fire in any light circumstances.
): The flash will not fire in any light circumstances.
) before setting up
) or ( ), ( /
): The camera will judge the necessity of
6
) will show on TFT LCD