BenQ DC 2300 User Manual page 14

BenQ DC 2300 User's Manual
3. Press Right Direction Button (
You can press Menu Button to cancel the slide show.
VIII. Set An Image At Protect Status Or Cancel The Protection Of
An Protected Image
Please set the Mode Dial at Playback Mode (
Button to enter "Play" menu table.
IX. To Set An Image At Protect Status (Preset at Unlock)
To set an image at protect status can prevent the selected image from erasing.
1. Select "Protect".
2. Select "Lock" to protect the selected image.
3. Press Right Direction Button (
After above steps are done, please check if the (
shown please repeat the steps again.
X. To Cancel The Protection Of An Protect Image
1. Select "Protect".
2. Select "Unlock" to cancel the protection.
3. Press Right Direction Button (
XI. Print Out An Image With A Printer Without Going Through PC (Preset
at X0)
Please set the Mode Dial at Playback Mode (
"Play" menu table. Use Up Direction Button (
( ) to move the color bar to the feature you would like to set up.
1. Select "Prints ".
2. Select the number of copies you would like to print out from X0 to X9. The
number means the number of the copies you would like to print out.
3. Take out the memory card from the camera and put it into the card reader
slot of the printer.
4. Set the printer at DPOF Print and then the printer will print out the selected
image(s) according to the set number(s).
) to start the slide show.
) and press Menu
) to confirm the setting.
Note
) is shown on the right side. If it is not
) to confirm the setting.
) and press Menu Button to enter
) and Down Direction Button
11