Maintenance & Care - Bissell PROHEAT 2X REVOLUTION MAX PROFESSIONAL User Manual

Emptying the Dirty Water Tank
WARNING
disconnect plug from electrical outlet before performing maintenance or troubleshooting.
1
To release Dirty Water
Tank, press down on the
coloured tank handle.
4
Cleaning Machine After Use
1
First, fill the Clean
Water Tank with
warm tap water
and then empty it
all to rinse. Then fill
again with warm
tap water and
return the tank to
the machine. Twist
cap back on tightly.
To reduce the risk of fire, electric shock or injury, turn power OFF and
2
Tilt the tank slightly toward
you. Grab the handle and
tank with both hands.
For quick empty:
Pull the Rubber Tab and
tilt to pour. When closing
the tab, make sure all
edges are sealed tight.
For final clean and
rinse: Unscrew the ring
at the bottom of the
tank. Remove the Float
Stack and rinse and
clean. Once clean, put
float back in tank by
lining up the arrows so
they point at each other.
With arrows aligned, the
float should lock into
place. Return the ring
and twist to lock. Water
may leak if it's not tight.
2
3
Pull Dirty Water Tank up
and away to remove.
5
6
Did You Know?
The Float Stack is what
prevents your Dirty
Water Tank from
overflowing.
To flush and rinse machine:
Turn the machine ON and
press the Spray Trigger for 15
seconds while making back
and forth passes on a section
of carpet. Release the trigger
and suck up the water.
Empty the Clean Water Tank
and let dry before storing.
Wipe your machine's exterior
with a soft cloth.
www.BISSELL.com.au
Clean the red filter
below the Dirty Water
Tank by wiping off
any remaining dirt or
debris.
Angle the tank and
insert bottom first.
Then tilt the tank
toward the machine
and push the top in
until it clicks into place.
11