Advertisement
Table of Contents
My ProHeat 2X® Revolution® Pet Carpet
Cleaner has no suction to the hose | Support
•
Machine must be in upright position for suction at the hose
•
If dirty tank is full, it must be emptied
•
Check both tanks for cracks or other damage
o
If part is damaged, it will need to be replaced
•
Check the bottom of the water tank to make sure it has a red auto-load gasket attached
•
Tanks must be seated properly
o
To return the dirty tank, angle the tank and insert bottom-first
o
Tilt the tank toward the machine and push the top in until it clicks into place
•
The clean water tank will not click, but should sit flush with no gaps
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Bissell ProHeat 2X Revolution Pet
Summary of Contents for Bissell ProHeat 2X Revolution Pet
- Page 1 My ProHeat 2X® Revolution® Pet Carpet Cleaner has no suction to the hose | Support • Machine must be in upright position for suction at the hose • If dirty tank is full, it must be emptied • Check both tanks for cracks or other damage If part is damaged, it will need to be replaced •...
- Page 2 • Dirty tank plug needs to be pushed in securely Suction will be reduced if there are gaps • Reinsert the hose • Be sure the colored hose release clip is facing out, away from machine...
- Page 3 • Check hose for cracks or damage Hose will need to be replaced if damaged • Check hose for clogs Remove hose and run clean water through one end, hold other end over sink - water should flow through • Check red filter screen under dirty tank for debris •...
Need help?
Do you have a question about the ProHeat 2X Revolution Pet and is the answer not in the manual?
Questions and answers