Step 14 Setting The Indoor Unit Addresses And The Installation Options - Samsung ACTN4PEH Series Installation Manual

Step 14 Setting the indoor unit
addresses and the installation options
You cannot set both of the indoor unit addresses and
the installation options in a batch: set both of them
respectively.
Common steps for setting the addresses and
options
Entering the
mode for setting
the options
High Temp button
Low Temp button
NOTE
• The remote control display and buttons may vary
depending on the model.
1 Enter the mode for setting the options:
a Remove the batteries from the remote control,
and then insert them again.
b While holding down the
(Low Temp) buttons simultaneously, insert the
batteries into the remote control.
c Make sure that you are entered to the mode for
setting the options:
2 Set the option values.
• The total number of available options are 24: SEG1 to
• Because SEG1, SEG7, SEG13, and SEG19 are the page
• Set a 2-digit value for each option pair in the following
Setting the
option values
Mode button
High Fan button
Low Fan button
(High Temp) and
CAUTION
SEG24.
options used by the previous remote control models,
the modes to set values for these options are skipped
automatically.
order: SEG2 and SEG3 SEG4 and SEG5 SEG6 and
SEG8 SEG9 and SEG10 SEG11 and SEG12 SEG14
and SEG15 SEG16 and SEG17 SEG18 and SEG20
SEG21 and SEG22 SEG23 and SEG24
SEG1 SEG2 SEG3
0 X X
SEG7 SEG8 SEG9
1 X X
SEG13 SEG14 SEG15
2 X X
SEG19 SEG20 SEG21
3 X X
On (SEG1 to SEG12)
SEG4 SEG5 SEG6
X X X
SEG10 SEG11 SEG12
X X X
SEG16 SEG17 SEG18
X X X
SEG22 SEG23 SEG24
X X X
Off (SEG13 to SEG24)
English
19