Electrical Connections - Mandik CPV Installation, Commissioning And Maintenance

MANDÍK CPV Installation, commissioning, and maintenance
Phosphate content converted to P

6.8 ELECTRICAL CONNECTIONS

Any intervention into electrical panels or connection of the provided components may only
be performed by personnel with professional qualifications under the valid legislation in the
country of installation of the equipment!
Individual components of the unit are typically wired from the factory to the terminals of the
controller and tests (fans, sensors, actuators, thermostats, manostats, electric heater, etc.).
It is only necessary to connect the provided peripheral devices (the POL822 room unit, Touch
Panel, CO2 sensor, piping temperature sensor, control loop, etc.) All connection schematics
are provided in the design documentation package for the unit, "MANDÍK Air Handler
Controls".
The mains connection for the unit is typically provided via a receptacle installed right next to
the main switch. The type of receptacle is specified in the technical specifications of the unit,
and the manner of installation is illustrated below.
If the unit is not equipped with a main power receptacle from the factory and a separate mains
connection is required, the threaded cable gland next to the main switch is used for this purpose.
Fig 7 Main connection for the unit and main switch
The provided threaded glands located right next to the main switch are used to connect the
provided peripherals to the terminal block.
IZU 06/2021
O , min. 15 mg.l .
2 5 -1
MANDÍK, a.s., www.mandik.cz
MAINS CONNECTION
MAIN SWITCH
R
17