Mandik CPV Installation, Commissioning And Maintenance page 11

MANDÍK CPV Installation, commissioning, and maintenance
Openings are provided in the frame of the units for handling. During use, pallet truck
forks must remain fully under the chamber.
2) Preparation and handling using a forklift
Openings are provided in the frame of the chamber for handling. During use, the forklift
forks must remain fully under the chamber, see the illustration.
ATTENTION: The chamber is not evenly balanced in terms of weight. Handling
activities and lift heights must be adapted appropriately!
3) Chambers are transported and handled on non-returnable pallets
During use, the forks on the forklift or pallet truck must remain fully under the pallet.
ATTENTION: The chamber is not evenly balanced in terms of weight. Handling
activities and lift heights must be adapted appropriately!
4) Handling with the unit using steel tubing and straps
The tubing must be passed through the round openings in the corner of the frame over
the entire length, or width of the unit. The tubes must extend past the straps
a minimum of 100 mm. It is best to equip the ends of the tubes with clips to prevent the
straps from slipping. Use tubing 40 to 45 mm in diameter. Use tubing with a minimum
wall thickness of 5 mm. The minimum clamping angle of the strap to the upper edge of
the unit is 50°.
Only transport the unit in its horizontal working position.
To prevent deformation in the unit at the locations where pressure is applied by straps,
ensure the straps are properly spaced above the unit or these points are protected with
sufficiently rigid reinforcement.
ATTENTION: Only suitable and permitted rigging equipment may be used for handling
and transport of units!
Comply with all valid technical regulations and legislation in the given country during
handling. For example: ČSN EN 13 155+A2, ČSN ISO 12480-1.
IZU 06/2021 MANDÍK, a.s., www.mandik.cz
R
11