HIKVISION DS-C12A User Manual page 33

Note
All cables mentioned in the following table require you to purchase separately.
No.
1 Grounding cable
2 Network cable
3 Video and audio cables 1. Connect the HDMI input interfaces to input signal
4 Loop cable
5 Sync cable
Video Wall Controller User Manual
Table 4-2 Cable Connection Description
Cable
1. Use a Phillips screwdriver to remove the grounding
screw on your device.
2. Use the Phillips screwdriver to connect one end of the
grounding cable to the grounding terminal of your
device and the other end to the grounding system.
Connect the LAN interface of your device to the network
using a network cable.
sources and the HDMI input interfaces to the video wall
with HDMI cables.
- Only HDMI 2.0 cables are supported.
- If your site requires signal conversion cables, choose
2. Connect the line out interface to the audio device such
as a loudspeaker with an audio cable.
1. Connect the loop out interface of the master device to
the loop in interface of one of the slave devices with an
HDMI cable.
2. Connect the loop out interface of the slave device to
the loop in interface of the next slave device with an
HDMI cable. The rest can be done in the same manner.
1. Connect the sync out interface of the first device to the
sync in interface of the next device with a network
cable.
2. Connect the sync out interface of the device to the sync
in interface of the next device with a network cable.
The rest can be done in the same manner.
Connection Method
Note
cables based on your actual needs. For the
controllers, DP-HDMI cables support up to 4K@60 Hz
input, DVI-HDMI cables support up to 4K@60 Hz
input, and VGA-HDMI cables support up to
1080P@60 Hz.
24