Add Devices By Ip Segment - HIKVISION DS-C12A User Manual

View Device Status
Edit Device
Information
Refresh
Delete Device

2.2.2 Add Devices by IP Segment

If the devices share the same port No., user name and password, and their IP addresses range in
the same IP segment, you can add them to the client by specifying the start IP address and the end
IP address, port No., user name, password, etc of the devices.
Steps
1. Click Maintenance → Device Management .
2. Click Add to open the Add window.
3. Select IP Segment as the adding mode.
4. Enter the required information.
Start IP
Enter a start IP address.
End IP
Enter an end IP address in the same network segment with the start IP.
Port
Enter the device port No. The default value is 8000.
User Name
By default, the user name is admin.
Password
Enter the device password.
Caution
The password strength of the device can be automatically checked. We highly recommend
you change the password of your own choosing (using a minimum of 8 characters, including
at least three kinds of following categories: upper case letters, lower case letters, numbers,
and special characters) in order to increase the security of your product. And we recommend
you change your password regularly, especially in the high security system, changing the
password monthly or weekly can better protect your product.
Video Wall Controller User Manual
Click on Operation column to view device status, including
cameras, recording status, signal status, hardware status, etc.
Click on Operation column to edit the device information, such as
IP address, user name, and password.
Click on Operation column to get the latest device information.
Select one or multiple devices and click Delete to delete the selected
device(s) from the client.
8