Table of Contents
Advertisement
2.2.1 Add Device by IP Address or Domain Name
If you know the IP address or domain name of the device to add, you can add devices to the client
by specifying the IP address (or domain name), user name, password, etc.
Steps
1. Click Maintenance → Device Management .
2. Click Add to open the Add window, and then select IP/Domain as the adding mode.
3. Enter the required information.
Name
Create a descriptive name for the device. For example, you can use a nickname that can
show the location or feature of the device.
Address
The IP address or domain name of the device.
Port
The devices to add share the same port number. The default value is 8000.
User Name
Enter the device user name. By default, the user name is admin.
Password
Enter the device password.
Caution
The password strength of the device can be automatically checked. We highly recommend
you change the password of your own choosing (using a minimum of 8 characters, including
at least three kinds of following categories: upper case letters, lower case letters, numbers,
and special characters) in order to increase the security of your product. And we recommend
you change your password regularly, especially in the high security system, changing the
password monthly or weekly can better protect your product.
Proper configuration of all passwords and other security settings is the responsibility of the
installer and/or end-user.
4. Check Synchronize Time to synchronize the device time with the PC running the client after
adding the device to the client.
5. Finish adding the device.
- Click Add to add the device and back to the device list page.
- Click Add and New to save the settings and continue to add other device.
6. Optional: Perform the following operation(s).
Remote
Configuration
Video Wall Controller User Manual
Click
on Operation column to set remote configuration of the
corresponding device.
7
Advertisement
Table of Contents
