Change A Device Topology; Check Device Topology Status - HIKVISION DS-C12A User Manual

3.3.1 Change a Device Topology

You can change the device topology as needed.
Steps
1. Click Artistic Configuration → Device Topology . The client automatically configures a cascading
topology for your devices, and you can connect physical devices according to the topology.
2. Change connection lines in the topology as needed.
Operation
Add or delete a device
Change a connection line
Change a loop line
Note
• The topology relationship must be consistent with the actual device relationship.
• After the cascading topology is configured, only the HDMI input interface of the master
device can be used to input signals.

3.3.2 Check Device Topology Status

You can check device information and topology status on the client, such as the device cascading
relationship, cable connection status, and status of signal input and output interfaces.
Video Wall Controller User Manual
Figure 3-7 Configure a Device Topology
Table 3-5 Description of Changing the Device Topology
Click Create or Delete to add or delete a device.
Click one interface, hold and move your mouse to draw a
connection line to the other interface.
Click the loop out interface of one device, hold and move your
mouse to draw a connection line to the loop in interface of the
other device.
Description
16