Load Calibration Data From A Usb Stick; Copy Calibration Data To A Usb Stick - Micromeritics ACCUPYC II 1345 Operator's Manual

L C
OAD ALIBRATION
Display Text
Calibration Type?
Load from USB Stick
Insert USB stick
and press [ENTER]
Local cal for SN:
Calibration for
SN (nnnn) copied
Remove USB stick
C C
OPY ALIBRATION
Display Text
Calibration Type?
Copy to USB Stick
Insert USB stick
and press [ENTER]
Calibration for
SN (nnnn) copied
Remove USB stick
AccuPyc II 1345 Operator Manual
134-42851-01 (Rev -) — Not Released
D USB S
ATA FROM A
Description
Press CHOICE until the option is displayed. Press ENTER.
Insert the USB device into the USB connector on the rear panel of the
unit. Press ENTER.
Key in the serial number. Press ENTER.
Display the unit for which calibration information has been copied.
Remove the USB stick. The system automatically returns to the
Reload prompt. This prompt appears immediately after the Calibration
for SN prompt.
D USB S
ATA TO A TICK
Description
Press CHOICE until the option is displayed. Press ENTER.
Insert the USB device into the USB connector on the rear panel of the
unit. Wait a few seconds, then press ENTER.
Display the unit for which calibration information has been copied.
Remove the USB stick. The Reload prompt displays. This prompt
appears immediately after the Calibration for SN prompt.
Load Calibration Data from a USB Stick
TICK
10 - 21