Motor Shaft Bearing - Husqvarna K 535i Workshop Manual

3. Use the larger hole of the bearing press.
4. Make sure that the bearings are in level before you
push them.
5. To put the second bearing to the blade shaft, use
the smaller hole of the bearing press.

6.18 Motor shaft bearing

6.18.1 To remove the motor shaft bearing
1. Remove the cutting arm. Refer to
cutter arm on page 16 .
2. Remove the pulley. Refer to
pulley on page 15 .
744 - 002 -
To remove the
To remove the motor
3. Remove the motor. Refer to
motor on page 15 .
4. Remove the bearing with an internal bearing
extractor and slide hammer. Refer to
overview on page 7 .
6.18.2 To install the motor shaft bearing
• Use the bearing press and the bearing press
adapter to install the bearing. Refer to
tools overview on page 7 .
To disassemble the
Servicing tools
Servicing
Repair instructions - 19