Replacement Of Engagement Roller Bearing Socket 9 - Husqvarna K3600 Mk II Workshop Manual

REPLACEMENT OF ENGAGEMENT ROLLER BEARING SOCKET 9

506 37 53-01
A
Removal
Tool
A special tool produced by Husqvarna is required in order to replace the
bearing socket. Item no. 506 37 53-01.
Tip
Removing the water disc facili -
tates the procedure.
Remove the bearing socket
Removal is a two step process:
Step 1
Fit the puller as shown in the
picture and press out the
bearing socket about one
centimetre/0.5 inch.
Step 2
Add the spacer ring and press
out the bearing socket.
Replaceable seals
Remove the seals using a sharp-pointed awl.
ring. The O-ring is fitted first and positioned outermost (against the roller).
the bearing socket (2). Use pliers that do not damage the seal surface; circlip
pliers are ideal. Shape the plastic ring in the bearing socket using a finger.
Grease in the stripper plate and press in the bearing bracket. After a few
B
minutes, pull out the bearing bracket and check that the stripper plate has
shaped itself correctly.
the O-ring.
1.
The stripper plate (A) comprises two components; an O-ring and a plastic
The plastic ring is first shaped around a round object (1) and then fitted in
The seal (B) is a simple O-ring that is fitted by hand without tools. Grease
2.
Tip
Removing the water disc facilitates the
procedure. Remove the 4 screws holding
the water disc in place and the screw
holding the water connection.
Remove the bearing socket
Removal is a two step process:
Step 1
Fit the puller as shown in the picture.
Only one ring should be used in the first
step. Press out the bearing socket about
one centimetre/0.5 inch.
Step 2
Remove the tool and fit the spacer ring
as shown in the picture.
Screw in the screw until the bearing
socket is fully out.
15