Table of Contents
Advertisement
Features are engaged. (See page 9.) If your unit presents an
led illumination pattern other than this standard power-up
test sequence, return it to beltronics for servicing.
To bypass the power-up test sequence, press the p/v button
twice. Your unit will be ready for operation after indicating
status of sws™ (led #1) and vg-2 Guard® (led #2).
Tutorial Mode
The tutorial mode allows you to become more familiar with all
audible and visual alerts. To engage this mode, press the
and
buttons simultaneously while the unit is
visual alerts will be presented slowly in order of Laser, K, Ka, X,
vg-2 Guard
"c" and "b" leds. After the tutorial mode, your unit will be on.
Memory Retention of Feature Selections
Any time your unit is turned
removed, all feature settings are retained in the unit's memory.
Memory retention eliminates the need to reset your preferred
feature settings each time your unit is turned off and then
back
.
Adjusting the Audio Level
Once your
level can be adjusted by continuing to press the
down. As you hear the audio level change, the numerals
To reverse the direction in which the audio level cycles,
briefly release, then reactivate the
Audio/Visual Alerts for Instant-On/Pulsed Radar
This type of signal appears suddenly when a Radar unit is
"triggered". The instant-on alert consists of an intense, three
second, X, K or Super Wideband Ka audio "burst", coupled
with the "ramping" illumination ( – ) of the 4-led display.
(Dim/Dark) Button
The
button allows selection of a dim or dark setting for
all leds. To engage dim mode, press the drk button once.
A single "beep" confirms your selection. To completely cancel
the illumination of all led
®
and sws
followed by the illumination of the "h" ,
™
Cordless is receiving power, the audio
provide a visual reference of the audio level.
or the batteries are
button.
, press drk a second time. You'll
s
. The audio/
button
Advertisement
Table of Contents
