5.2.1 Teaching-In To Altech V3 Ip Access Point - Altech ALEC-42090D Manual

If the room control unit shall be taught-in to the Altech V3 IP Base station, the two
devices to be linked must be set to teach-in mode.
1. Select the desired channel at the Altech V3 IP base station (see Altech V3 IP
Base station instructions).
2. Activate the teach-in mode at the base station by pressing and holding the key.
9 The device LED starts to flash in orange.
3. Take off the room control unit Display from the installation bottom (see page 5
DK
fig. 3).
NO 4. Pull out the insulating strip from the battery compartment, or insert batteries
(see page 5 fig. 4) If batteries have already been inserted, press the system key
SE
(D) for at least 4 seconds in order to activate the teach-in mode.
9 The teach-in mode is activated automatically for 3 minutes.
FI
9 The device LED flashes in orange.
FR
The LED will light up in green after a successful teach-in process. If the LED
GB GB
lights up red, repeat the process.
5.2.1 Teaching-in to Altech V3 IP Access Point
For a control via the IP app, the teaching-in must of the ALEC-42090D must be per-
formed via the Access Point (HAP 21001). Teach-in the device as follows:
Ö The Altech V3 IP Access Point has been set up via the IP App (see instructions
HAP 21001).
1. Open the IP app on the smart phone.
2. Select the menu item Teach-in device.
106