Hardware Installation - SEH ONE Quick Installation Manual

 Hardware Installation
A printer can be connected via the USB port of the printserver ONE and made
available in the network.
1. Turn the printer off.
2. Disconnect the power cord from the printer. (Interrupt power supply).
3. Connect the printer and the print server using the USB cable.
Important:
Only use USB cables shorter than 3 meters.
4. Connect the network cable (RJ-45) to the print server.
5. Connect the power cord to the print server.
6. Connect the power cord to the printer.
7. Turn the printer on.
Important:
In order to verify the installation you can print a status
page. To do this, press the print server's button for a
short time.
A status page can only be printed if the printer supports
the data formats ASCII, PostScript, DATAMAX (label
printer), or Citizen-Z (label printer).
6 [en] Quick Installation Guide