Mounting The Fmt On The Rack; Installing Vertical Cable Guides - CommScope ADCP-90-326 User Manual

3. If damage is detected or if parts are missing, file a claim with the commercial carrier and
then notify CommScope Customer Service. Save damaged carton for inspection by the
carrier.
4. Refer to
warranty information.
5. Save the shipping container for use if equipment requires shipment at a future date.

4 MOUNTING THE FMT ON THE RACK

For all mounting options, the FMT uses two mounting brackets, one on either side, with two
mounting holes in each bracket (see
mounting brackets for the required recess. Secure tray to rack using the screws (provided).
Note: In some configurations, the same screw is used for both the mounting bracket (top
hole) and the vertical cable guide (see
MOUNTING

5 INSTALLING VERTICAL CABLE GUIDES

Optional vertical cable guides (VCGs) may be installed with FMTs when space permits.
summarizes possible uses of VCGs for various combinations of rack width and recess.
1. If the rack width is 19 inches (48.26 cm) or ETSI (20.28 inches, 51.5 cm) and:
Section 8 Customer Information and Assistance
HOLES
Figure 4. FMT Mounting Holes
Table 2. Possible Uses of VGCs
RACK WIDTH
19 inches
(48.26 cm)
23 inches
(58.42 cm)
Figure 4). Determine what recess is required and adjust
Section 5 Installing Vertical Cable
VERTICAL CABLE
RECESS GUIDE
40 mm (1.54 inch) VCGs not advised
2.2-inch (5.59 cm)
3.1-inch (7.9 cm) Figure 5
5-inch (12.7 cm)
6.5-inch (16.5 cm)
Figure 6
40 mm (1.54 inch)
2.2-inch (5.59 cm)
3.1-inch (7.9 cm)
5-inch (12.7 cm)
6.5-inch (16.5 cm)
ADCP-90-326 • Rev B • November 2020
for repair, replacement, and
Guides).
20200-A
Table 2
© 2020, CommScope Inc.
Page 7