Table of Contents
Advertisement
6.4
Termination and Storage FMT Configuration
Cables routed into the FMT for termination and storage will typically be pre-terminated
individual cables of 2 mm or 3 mm outside diameter. For instructions on routing the cables within
the tray, select from the subsections below based on the tray configuration being installed.
6.4.1
12-Position Termination and Storage Tray, Universal Storage
Route and install the cables as shown in
KURLY
LOCK
Figure 11. Cable Routing for 12-Position Termination and Storage Tray, Universal Storage
ROUTE FIBERS ALONG THE
SOLID ARROW ON INDICATED
PATH, THEN FOLLOW THE
APPROPRIATE DOTTED LINE.
3
2
1
STORAGE
SPOOL
1 ROUTE THE FIRST 4 FIBERS THROUGH THE RIGHT SLIDING RADIUS LIMITER, AROUND THE
RIGHT REAR RADIUS LIMITER, AND AROUND THE 2 FAR RIGHT RADIUS LIMITERS. WRAP
FIBERS COUNTER CLOCKWISE AROUND THE RIGHT FRONT STORAGE SPOOLS AND ROUTE
TO THE FRONT 4 ADAPTERS ON THE RIGHT SIDE. WIND SLACK CABLE AROUND STORAGE
SPOOLS IN THE DIRECTION SHOWN.
2 ROUTE THE NEXT 4 FIBERS THROUGH THE RIGHT SLIDING RADIUS LIMITER, AROUND THE
RIGHT REAR RADIUS LIMITER, AND AROUND THE 2 FAR RIGHT RADIUS LIMITERS. WRAP
FIBERS COUNTER CLOCKWISE AROUND THE RIGHT FRONT STORAGE SPOOLS AND ROUTE
AROUND THE SINGLE RADIUS LIMITER TO THE NEXT 4 ADAPTERS ON THE RIGHT SIDE. WIND
SLACK CABLE AROUND STORAGE SPOOLS IN THE DIRECTION SHOWN.
3 ROUTE THE LAST 4 FIBERS THROUGH THE RIGHT SLIDING RADIUS LIMITER, AROUND THE
RIGHT REAR RADIUS LIMITER, AND AROUND THE 2 FAR RIGHT RADIUS LIMITERS. WRAP
FIBERS COUNTER CLOCKWISE AROUND THE RIGHT FRONT STORAGE SPOOLS AND ROUTE
AROUND THE SINGLE RADIUS LIMITER TO THE LAST 4 ADAPTERS ON THE RIGHT SIDE. WIND
SLACK CABLE AROUND STORAGE SPOOLS IN THE DIRECTION SHOWN.
4 REPEAT THE PROCESS FOR THE LEFT SIDE, WRAPING THE FIBERS CLOCKWISE AROUND
THE STORAGE SPOOLS.
Figure
11. Place kurly locks at locations indicated.
3
2
1
STORAGE
SPOOL
ADCP-90-326 • Rev B • November 2020
KURLY
LOCK
20283-A
Page 15
© 2020, CommScope Inc.
Advertisement
Table of Contents
