12-Position Termination And Splice Tray - CommScope ADCP-90-326 User Manual

6.6

12-Position Termination and Splice Tray

Note: Splicing instructions are not included. For splicing instructions, follow local practice.
Termination and splice trays provide 12 termination and splice positions. Install the cables for a
12-position termination and splice tray as follows:
1. Break out the cable corresponding to the dimensions provided in
2. Route the cables into the tray as shown in
tray at an adjacent work area, as shown. Perform the splices following local practice.
Refer to pigtail installation drawing (provided with FMT) for pigtail connection scheme.
3. Loop the cables three times around the radius limiters as shown in
Note: Tie off the cable at the tie off point shown in
soft wall jacket per the breakout dimensions shown in
900 MICRON
JACKETED
FIBERS
48 IN. (121.9 CM)
Figure 15. 12-Position Termination and Splice Tray Breakout Dimensions
4. Carefully position the tray within the splice area as shown in
the pre-terminated and customer fiber bundles are properly routed around the appropriate
radius limiters as they enter the FMT (see
5. Use the kurly locks provided to bundle fibers together as needed. Place kurly locks at
locations indicated in
6. Verify that the completed tray looks as shown (see
SECTION OF
SOFT WALL
JACKET
1 IN. (2.5 CM)
133 IN. (337.8 CM)
Figure 19.
ADCP-90-326 • Rev B • November 2020
Figure
Figure 16, and perform the splices outside the
Figure 17, using a one-inch section of
Figure 15.
Figure
Figure 18).
Figure 19).
15.
Figure 17.
SOFT WALL
PIGTAIL BUNDLE
16967-A
18. Make certain that
Page 19
© 2020, CommScope Inc.