Advertisement
®
NOTE: DO NOT install C-Clamp mount in a scallop
cut-out on the worksurface. Failure to follow these
instructions could reduce the stability of the arm.
If you have a problem, question, or request, call
your local dealer, or Steelcase Line 1 at
888.STEELCASE (888.783.3522)
for immediate action by people who want to help you.
(Outside the U.S.A., Canada, Mexico, Puerto Rico,
and the U.S. Virgin Islands, call: 1.616.247.2500)
Or visit our website: www.steelcase.com
©
2019 Steelcase Inc.
Grand Rapids, MI 49501
U.S.A.
Printed in U.S.A.
6
5
7
1
Attach base
assembly to
worksurface.
2
6
5
7
See note below
2
3
3
Drill
11/32"
hole
4
®
FYI
Dual Monitor Arm
FYI Dual Monitor Arm
(Not all tools required for
FPADUALCC
each mounting option)
FPADUALTM
100 - 105 in-lbs
(11.3 - 11.9 Nm)
4
6
Attach base
assembly to
worksurface.
Note: Located in Monitor
Arm Hardware Pack.
1
Power Drill
11/32" Dia. Drill Bit
#2 Phillips
Screwdriver
1/16", 5/32" & 1/4"
Allen Wrench
5/16 Wrench
Page 1 of 2
004166D Rev J
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Steelcase FYI FPADUALCC
Summary of Contents for Steelcase FYI FPADUALCC
- Page 1 If you have a problem, question, or request, call 5/16 Wrench Attach base worksurface. your local dealer, or Steelcase Line 1 at assembly to 888.STEELCASE (888.783.3522) worksurface. for immediate action by people who want to help you. (Outside the U.S.A., Canada, Mexico, Puerto Rico, and the U.S.
- Page 2 ® Slide monitor mount assembly onto end of arm until audible “click” is heard. Tighten set screw to prevent FYI Dual removal of monitor. Monitor Arm FPADUALCC RELEASE FPADUALTM Attach VESA Bracket to MECHANISM backside of monitor. Tools Required: SET SCREW To remove, loosen set screw, depress and hold release...
Need help?
Do you have a question about the FYI FPADUALCC and is the answer not in the manual?
Questions and answers