Gree GPH12AO-K5NNA1A Owner's Manual page 20

Installation of Heat Discharge Pipe
7. Connect Window adapter(top) to Window ada-
pter(bottom).
Window adapter(top)
Window adapter(bottom)
8. Rotate joint A and joint Window adapter(top) +
Window adapter(bottom) into the two ends of
heat discharge pipe.
Joint A
Heat discharge pipe
9. Insert joint A of heat discharge pipe into the gr-
oove until you hear a sound.
joint A
10. Slide and open the exhaust cover on the window
panel, and attach the window adapter.
Optional 2-2:
Installation in a sliding sash window
1. Attach the insect guard net to the window panel.
Window adapter(top)
Window adapter(bottom)
Groove
2. Cut the sponge A (adhesive type) to the proper
length and attach it to the window frame and to the
side of sash.
3. Install the window panel into the window frame.
Make sure that the exhaust cover is attached to
the window panel.
Inner height of the window:20.5"(520mm)
Use the window panel.
The window panel cannot be installed in windows less
than 20.5" (520mm) high, as you will be unable to shut
the exhaust cover.
(1) Open the window sash and place the window
panel on the window frame.
(2) Secure the window panel to the window frame
with screws.
Inner height of the window:20.5" (520mm)- 38.5"
(980mm) Use the window panel and the adjustment
panel.
(1) Open the window sash and place the window
panel on the window frame.
(2) Slide the adjustment panel to fit the window frame
height.
(3) Secure the window panel to the window frame
with screws.
16
Sponge A
Exhaust cover
Window panel
Cut
20.5" (520mm)