Install Power Cord Hooks; Removing Collected Water - Gree GPH12AO-K5NNA1A Owner's Manual

Preparation before Installation

Install Power cord Hooks

● Assemble the power cord hooks at the back of
the unit with screws (the direction of power cord
hooks is as shown in following fig).
direction of power cord hooks is upward
power cord hooks
screws
direction of power cord hooks is downward
● Wind the power cord around the power cord
hooks.

Removing Collected Water

There are 2 ways to remove collected water:
1
Use the drainage option from the lower hole.
In Cool, Dry or Heat mode operating, the condens-
ation water will be drained to the chassis.
When the chassis is full with water, the buzzer will
give out 8 sounds and "H8" is displayed to remind
user to discharge water, the unit will turned off 2min
latter, and all buttons are invalid.
To empty the chassis, please follow the instructions
bellow.
1. Turn the unit off and unplug from the electrical
outlet.
2. Use a small pan or move the unit to a suitable pl-
ace to drain the water.
3. Remove the pre-installed drain cap from the unit,
If you have selected the drainage hose, insert it
into the drainage outlet.
4. Drain the water into the small pan or a suitable place.
5. Once draining is complete,re-install drain cap.
6. Press ON/OFF button to restart the unit.
2
Use the continuous drainage option from the
middle hole
Notice
●
Water can be automatically emptied into a floor drain
by attaching 14mm inner diameter hose (not included).
1. Remove the continuous drain cap 1 by turning it
counter clockwise then remove the rubber stopper
2 from the spout.
1
Drainage port