Gree GPH12AO-K5NNA1A Owner's Manual page 18

Installation of Heat Discharge Pipe
Correct installation is as shown in figure (When
installing it on wall,height of hall should not be
over 130cm from floor).
130cm
Wrong installation is shown in following figure
(If the pipe is bent too much, it would easily
cause malfunction.)
Optional 1:
Installation in a double window
1. Connect Window adapter(top) to Window
adapter(bottom).
Window adapter(top)
Window adapter(bottom)
2. Rotate joint A and joint Window adapter(top)+
Window adapter(bottom) into the two ends of
heat discharge pipe.
Joint A Heat discharge pipe
Window adapter(top)
Window adapter(bottom)
3. Insert joint A of heat discharge pipe into the gro-
ove until you hear a sound.
joint A
4. Lead the exhaust hose outdoors.
Optional 2-1:
Installation in a double-hung sash
window
1. Attach the insect guard net to the window panel.
2. Cut the sponge A (adhesive type) to the proper
length and attach it to the window stool and to
the bottom of sash.
3. Attach the window panel to the window stool.
Make sure that the exhaust cover is attached to
the window panel.
Inner width of the window:20.5"(520mm)
Use the window panel.
14
Groove
Sponge A