Array Disassembling Procedure - L-Acoustics KARAi Rigging Manual

®
KARA
i
MODULAR WST
RIGGING PROCEDURES
VERSION 1.1
10. Repeat steps 8 and 9 until all KARAi enclosures composing the array are assembled.
11. Secure the fixation points on the top KARAi as follows (repeat on both sides of the enclosure):
a. Drive a 35 mm Torx
b. Drive a 55 mm Torx
c. Fully drive the three remaining Torx
Top
KARAi
12. Secure the array to a fixed point by using a ratchet strap or any other equivalent material (not included).
6.4.3

Array disassembling procedure

Apply the above procedure in the reversed sequence.
KARA i _RM_EN_1-1
® SYSTEM
screw into the front top hole (T30 bit, 5 N.m/45 in.lb
®
screw into the rear top hole (T30 bit, 5 N.m/45 in.lb
®
screws (T30 bit, 5 N.m/45 in.lb
®
a.
c.
c.
Figure 33: Example of SB18i/KARAi mixed array
w w w . l - a c o u s t i c s . c o m
).
f
).
f
).
f
b.
c.
38