Array Disassembling Procedure - L-Acoustics KARAi Rigging Manual

8. If the array is intended to be flown in pullback configuration, mount a M-BUMPi bar to the bottom KARAi as
follows:
a. Undo the two flat-head Torx
b. Position an M-BUMPi bar face to both holes and drive two round-head 35 mm Torx
M-BUMPi package) (thread-locker, T30 bit, 7 N.m/63 in.lb
c. Attach a shackle to the rear center point of the bar.
d. Attach the hook or stinger of an additional motor to the shackle.
Refer to [9.1.3] for pullback setup safety limits.
WARNING
9. Adjust the height and the site angle of the array [9.1.2].
10. Secure the M-BUMPi to the main rigging structure using two safety slings (not included).
6.1.3

Array disassembling procedure

Apply the above procedure in the reversed sequence.
KARA i _RM_EN_1-1
screws on holes shown in Figure 10 (T30 bit).
®
b. c.
a.
Bottom
KARAi
Figure 10: Setting the array in pullback configuration
w w w . l - a c o u s t i c s . c o m
®
).
f
d.
screws (included in the
b. c.
a.
15