Array Disassembling Procedure - L-Acoustics KARAi Rigging Manual

7. Repeat steps 5 and 6 until all KARAi enclosures composing the array are assembled.
8. Secure the fixation points on the top KARAi as follows (repeat on both enclosure sides):
a. Drive a 35 mm Torx
b. Drive a 55 mm Torx
c. Fully drive the three remaining Torx
Top
KARAi
6.3.3

Array disassembling procedure

Apply the above procedure in the reversed sequence.
KARA i _RM_EN_1-1
screw into the front top hole (T30 bit, 5 N.m/45 in.lb
®
screw into the rear top hole (T30 bit, 5 N.m/45 in.lb
®
screws (T30 bit, 5 N.m/45 in.lb
®
Figure 24: Example of KARAi standalone array
w w w . l - a c o u s t i c s . c o m
).
f
).
f
).
f
a.
c.
c.
b.
c.
29