Karai; M-Bumpi; Karaisb18Link - L-Acoustics KARAi Rigging Manual

®
KARA
i
MODULAR WST
RIGGING PROCEDURES
VERSION 1.1
5 KARA RIGGING COMPONENTS
i
®
5.1

M-BUMPi

The L-ACOUSTICS ® M-BUMPi rigging structure has been designed to fly or stack KARAi
curvature, vertical line source array. Note: M-BUMPi also can fly straight vertical SB18i arrays.
The M-BUMPi package is composed of:
 Ten bars.
 A set of M8 hex bolts to assemble the bars and obtain one or two M-BUMPi structures (see notes below).
 Two shackles fitted with a 19 mm/0.75 inch-diameter bolt and a safety pin each.
 A set of M6 hex bolts and washers to attach a KARAi or a SB18i enclosure to the M-BUMPi.
 A set of screws to fix a bar to the bottom KARAi of a flown array and obtain a pullback configuration.
Note 1: In flown configuration, the M-BUMPi can be assembled according to eight rigging options [9.1.1]. In
particular, rigging option 0 allows assembling two M-BUMPi. In addition, a bar can be used for aesthetic purposes (see
the right box in Figure 3).
Note 2: In stacked configuration, the M-BUMPi can be assembled according to two platform configurations [9.2.1].
Any of them allows assembling two M-BUMPi.
5.2

KARAiSB18LINK

The L-ACOUSTICS
KARAiSB18LINK accessories
allow rigging a KARAi array
below a SB18i array in flown
configuration.
The KARAiSB18LINK are two
plates (KARAISB18LINK 640
and 917) to fix on the KARAi
enclosure sides.
KARA i _RM_EN_1-1
® SYSTEM
Bar (x8)
Figure 3: M-BUMPi rigging structure
®
KARAISB18LINK 640
Figure 4: KARAiSB18LINK rigging accessories
w w w . l - a c o u s t i c s . c o m
Shackle (x2)
M-BUMPi assembled with an additional
front bar for aesthetic purposes
KARAISB18LINK 917
® enclosures as a variable-
8