3. Thoroughly rinse the components under running water.
4. For the frame sleeves, squeeze with a clean towel to remove excess
water. Shake the QuietAir vent to remove any excess water. Leave
the components to air dry out of direct sunlight.
If the mask components are not visibly clean, repeat the cleaning steps.
Reassembling your mask
1. Connect the elbow into the top of the frame until it clicks.
2. Insert the headgear strap into the frame and fold the fastening tabs
backwards.
3. Insert the ends of the frame into the cushion, ensuring that the arrows
on the cushion and frame are aligned.
Note: If the elbow ring detaches, re-insert into the top of the frame.
Removing/inserting the QuietAir vent
1. To remove the vent, gently pull the cushion away and slide the vent
out.
2. To insert the vent, align the tab (a) on the cushion with the notch (b)
on the vent, and then gently pull the cushion over the vent.
4