Powered Chip Brush; Prior To Operation; General Operating Procedure; Manual Lube System - Jet Elite ECB-1833DMEVS Operating Instructions And Parts Manual

11.12 POWERED CHIP BRUSH

The wire brush is driven by the motor via the belt. Keep
the brush in contact with the blade to prevent excess
debris from entering the wheel track; this will help pro-
long the life of the blade. To adjust, loosen the 2 socket
head screws (A, Fig. 11-9). After positioning, retighten the
screws.

12.0 PRIOR TO OPERATION

1. Verify that correct blade is installed for type of material
being cut.
2. Check that blade tooth direction matches arrows on
red blade guides.
3. Check to see that blade is properly seated on wheels
and correct blade tension is applied.
4. Adjust carbide guides if needed. See sect. 11.4.
5. Position left blade guide as close to workpiece as
possible without obstruction.
6. Select proper speed and feed rate for material being
cut.
7. Material to be cut must be securely held in vise.
8. Check to see that coolant level is adequate. If needed,
add coolant by pouring into chip tray so that it drains
through the strainer into basin.
9. Do not start cut on a sharp edge.
10. Keep machine lubricated. See sects. 13.1 and 15.0.
ECB-1833DMEVS
13.0 GENERAL OPERATING
PROCEDURE
1. Adjust left blade guide bracket as close as possible to
the left vise jaw, without causing obstruction.
2. Use the controls to raise the saw head, and turn the
feed rate dial to zero.
3. Move working table forward or back into the required
position based on cutting angle.
4. Adjust the angle of cut.
5. Place the stock between the vise jaws, position the
stock for the desired length of cut and clamp it with the
vise.
6. Start the blade and turn on coolant system. Adjust
coolant fl ow using the individual valves.
7. Set feed rate until saw blade begins to lower at desired
rate of speed.
8. Proceed to cut through the workpiece. The blade will
shut off at end of cut in manual mode; the saw head
will return to raised position in auto mode.
Fig. 11-9

13.1 MANUAL LUBE SYSTEM

See Fig. 13-1.
Pump handle (A, Fig. 13-1) once per 8 hours of operation
to circulate oil to key places on the machine.
CAUTION: Do not pump multiple times - this may cause
the connecting hose to burst or come loose.
Check oil level daily in the sight glass (B); top off if needed
with hydraulic oil. See sect. 14.0.
B
A
Fig. 13-1
15