Table of Contents
Advertisement
3gb66016.fm Page 15 Monday, August 19, 2002 11:59 AM
INSTALLATION - TECHNICAL INFORMATION FOR THE
INSTALLER
Discharge of combustion products
The combustion products of gas appliances must be discharged
through hoods connected directly to the outside.
When this is not possible, an electric fan can be used, attached to
the outside wall or to the window, The fan must be able to ensure
an hourly exchange of air 3-5 times the volume of the kitchen.
The fan can only be installed if there are suitable openings for
the air inlet.
Installation
- Remove the protective film from the cooktop.
- Cut an opening in the countertop to the dimensions shown in
the Product Description Sheet supplied separately.
- Stretch gasket (C) over the edge of the opening being careful
to overlay the junction edges.
- Turn the cooktop upside down and put tabs (A) into the seats
provided, tightening screws (B).
Please make sure that the tabs are correctly positioned as
illustrated.
- Position the cooktop into the housing.
- Put tabs (A) into place; tooth (D) of the tabs should fit into
the hole.
- Tighten screw (B) until the cooktop is completely secured.
Installing two cooktops side by side
To install two cooktops side by side (see figure), use the special
kit (code N° AMH 719) available from the After-Sales Service:
- Cut an opening in the countertop, as illustrated in the figure.
- Please observe the installation instructions for a single
installation.
- A 5 mm space must be left between the cooktops to fit the
junction piece.
- For installations with more than 3 cooktops side-by side,
calculate the hole needed, referring to the dimensions shown
in figure.
- Each cooktop must have its own gas/electrical supply.
2 DOMINO side-by-side
3 DOMINO side-by-side
15
Advertisement
Table of Contents
